The hardware and software used in this tutorial. Uploads 256KB code in 14 seconds (XMEGA using JTAG. 3 hardware program breakpoints and 1 maskable data breakpoint (depending on the OCD module on the AVR microcontroller) Symbolic debug of complex data types including scope information. IAR Embedded Workbench for AVR 5.40 will then work on a Windows XP 64-bit system.Īll product names are trademarks or registered trademarks of their respective owners. Learn how to debug SAM-based Arduino boards using the Atmel-ICE debugger and the Arduino IDE 2.0. Supports JTAG, aWire, SPI and PDI interfaces. If you install AVR Studio Version 4.18, with Service packs 1 and 2, this will update the USB drivers, and the firmware in the JTAGICE mkII. ![]() The JTAGICE mkII driver can, from version 5.40, be used on 64-bit versions of Windows Vista and Windows 7 but not 64-bit XP. The batch file is located in the directory avr\drivers in the product installation.įor IAR Embedded Workbench for AVR version 6.11 and later, follow the instructions in the JTAGICE mkII Driver Release Notes (the driver installation package is for example named AVRJungoUSB.exe, AtmelUSB.exe or AtmelUSBInstaller.exe - located in avr\drivers\Atmel).įor IAR Embedded Workbench for AVR version 6.80.1 through 6.80.8, Jungo version 12 is used.įor IAR Embedded Workbench for AVR version 6.80.9 and 7.10.1 and later, Jungo drivers have been replaced by WinUSB drivers. You need to manually install this driver as recommended in the Release Notes for the JTAGICE mkII driver.įor IAR Embedded Workbench for AVR version 5.40 to 6.10, run the batch file install.bat. These versions use a new version of the Jungo driver (v10.1.00). It lets you select and configure software components, drivers and middleware, as well as complete example projects specifically tailored to the needs of your application. If you have upgraded to IAR Embedded Workbench for AVR version 5.40 or later: Atmel START is an innovative online tool for intuitive, graphical configuration of embedded software projects.When debugging a project the following message appears: Failed to initialize USB driver: error 0x2000001c ("Incorrect WinDriver version installed") Solution
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |